- Dump Valve Operating correctly?
- Cam options for phase 1 heads
- MY98 Impreza Starting Problems.
- MY05 UK STi - Oil Change Cycles?
- day 1 complete
- induction kit sucking on idle ??
- Subaru special engine tooling.
- where can i get these senders?? (oil temp/oil pressure)
- EJ20G injector removal instructions
- Unknown gadget
- water leak
- HELP !! Need to source two connectors asap
- Castrol Offer This Weekend
- What model is this exhaust for?
- 2.2 non turbo to turbo
- Fuel Consumption?
- Juddering and feeling sloppy
- 1-AN to 6AN
- newage - engine out and head gasket change
- fone number for andy at ESL??
- Do I still need a map sensor if fitting a Apexi AVCR
- CV Boot fitting
- problem with fuel pump
- Subaru Spring Check
- Estate letting in water
- Any Info on These Shocks?
- Taking engine out
- Need a clutch I think
- Diagnostics Port
- Apexi power fc & different boost settings
- Couple of quick questions
- Apexi hand controller instructions in English?
- Poor running................! help, please....!
- Fitting back box
- MY00 Hicup
- END OF THE ROAD??? Plz HELP!
- info please neutral switch
- estimated power & torque
- fitting oil catch tank
- How did I blow it up?
- Spark plugs for '96 WRX 340bhp ?
- How much should i ask for these heads?
- what sort of power would the following give me?
- how to wire AFR gauge into standard lambda
- got new gauges for water and oil temp...where do i put the senders on to ??
- new gaskets for bellmouth decat dp. do i need any special ones etc to fit it ??
- Quick cat and emissions question
- Steering Wheel Rattle
- Air con compressor not starting after rad change
- Heater matrix troubles. My head is battered!!!!!
- no lambda??? is it poss?
- Prodrive intercooler pipe?
- Urgent advise needed please
- Intercooler upgrade ?
- Do i need anything else?
- would this give 380bhp
- How to stick gauge pod down?
- Wheel bearing size?
- Power FC on Auto Transmission
- ANYONE GOT A NEWAGE WITH BACK BOX & BOV FITTED
- New Age Dump Valve
- servicing
- Pipe Bore of standard Dump Valve Pipe
- Fans on Sti Intercooler
- A few questions from a newbie.
- Mounting the front mount intercooler
- Speedo converter
- refit standard ECU after PFC
- Lambda sensor
- knocking noise
- what oil??
- FMIC HELP PLEASE
- New age spark Plugs
- problems starting
- Bonnet wont open!
- ARE TURBO TIMERS WORTH GETTING????
- TURBO TIMER
- ht leads
- Whats a good
- Going back to standard recirc valve
- ECU Tek remap 01MY WRX
- oil temp do i have a problem
- urgent help required with harvey's ported headers and up pipe
- Stand alone ECU options
- PR DEVELOPMENTS