- Which models are available as NA?
- Which Oil
- Who can do an MOT in the East Mids
- Do 2drs and 4dr classics have the same floor pan?
- Uprated AFM for new age? What does Andy Forrest use??
- golf mark 4 gti
- JDM STi V7 ECU/ UK STi V7 ECU
- Induction Kit & Cold Feed Setup Recommendations
- rear wheel judder in reverse help!
- Leaking Upipe on P1 advice please..
- Exhaust advice needed
- 05 WRX Fog Cover Fitting?
- Version 4 STI type R wiring diagram
- Anti Lag
- 10w50 or 5w40 for sti engine running 400bhp ?
- Extended Service Manual STi/WRX 08
- what is the cold start idle?
- Prodrive/Remap/Fitting/Green Filters etc...
- pfr7b plugs
- Oil temp sender leaking !
- Building your own engine
- 95 wrx td05?
- Hole in manifold
- WHERE TO WIRE A TACHO IN A CLASSIC
- CAI for early classic?
- What sort of figures from a UK classic
- Bricked Scooby! Immobiliser lock-out and dealer code no good?!
- starter motor bolts threaded help please?????
- what next??
- Help Tinny Knocking sound from scooby
- shud i remove air con rad
- Newage Harness Bar
- walbro fuel pump fitting
- poss MAJOR problem
- subaru wagon questions
- New guy needs help !!!!!
- closed deck engine rebuild
- Timing Belt Change
- What should my next engine mod be ?
- Need new front discs and pads?? (2005 blob eye wrx)
- How weird was that- non startor
- dump valve
- Simtek Air sensor relocation
- Car won't start ??
- Engine torque setting
- Bit of a problem occured!! Help!!
- FMIC on Hawkeye 2.5 WRX
- speedo converter problems
- 98 turbo 200 ecu choice
- 1998 import impreza WRX hesitation
- td05
- Spooling RPMs of TD04 vs 05 and 06
- Closed deck blocks again
- Wagon rear lights
- bad compression
- arch rolling or flaring flare
- best way to refit black pipe under turbo
- Painting inlet manifold
- 03 Sti Lambda sensor...please help
- are japspeed catback loud ?
- sti intercooler with wrx undertray possible?
- Front splitter for bugeye.
- Newbie - EJ20 bored to 2.1
- Fuel advice
- Changing twin scroll to single scroll
- Compression Test
- rebuild engine or engine conversion
- lightened pully set
- Need a SQV adaptor plate for my 01 bugeye, is this the right one??
- Does the Blobeye Still have a Cone Ring & Spring Bolts for the Exhaust ??
- Which Exhaust
- My engine type code does not exist?
- Intercooler paint
- facelift lights
- 350BHP TMIC??
- 20G on a 2.5 what kind of figures?
- Whats an oil catch tank
- Engine management light...not the usual!
- Mapping Question
- ECUTek Tuners....
- 55 Blob STI high idle ?
- 3in Nur Spec R?
- help needed!!!
- 4pot dust seals
- hand brake turns