- Ej205 UKDM turbo oil feed issue
- Classic misfire
- 2002 subaru impreza engine rebuild
- Turbo blanket
- Best way to prevent newly machined block corroding before fitment?
- Possible EJ22 motor build question
- Cam belt choice hawkeye
- Subaru WRX
- Best Turbo for sub 400bhp?
- Up pipe
- Wich is the best dump valve ?
- avcs and turbo oil feed ?
- yes please would love this
- Sti heads onto a wrx newage, is it worth it?
- Knock sensor Subaru Impreza EJ18 1994 GL AWD
- Intake valves
- Genuine Spoiler Base
- Blitz Nur Spec alternative
- Roll cage?
- Early/later crank and cam sensors
- Engine management code P0021
- EJ18 Impreza GL AWD motor questions
- PAS Fluid
- alternator upgrade
- Jdm cams?
- Help please . Codes p1092, p1086
- need a new clutch what to get who to fit...
- Single piece Spec C manifold and fuel lines
- Hawkeye 2nd decat
- Gt2860rs any good?
- BOV not working?
- Not starting advice
- 2nd cambelt - yet?
- What to do whilst fitting cambelt
- Valve train help needed
- advice on upgraded washer bottle in new age
- Smell of constant petrol? Any ideas?
- Why does my up-pipe keep cracking???
- Need advice installing custom relay box in classic
- Actuator pressure!
- v3 coil pack to newage
- wheres my coolant going???
- Head gasket advice
- Steering problem
- Lost most of my coolant on the way home...
- Buying a v5 WRX STI
- Newage gearbox into a classic
- Prodrive back box from a blob fit a hawk?
- I'VE SAID IT BEFORE WARRANTY COMPANIES ARE A RIP OFF WITH A CAPITAL R
- Noisy oil catch can on newage
- Modified Oil Pumps
- APS dual vent BOV question
- Oil Temp Dropping to minimum.
- Fitting a FMIC on Newage
- New to Subaru, couple of silly questions
- FMIC for my Classic rally car
- Missfire
- Identify two plugs for me.
- Scooby sport help!!!
- 2004 Spec C Advice Please......
- crank shaft and engine clean and soda blast
- Dump valve
- 2004 wrx over heating
- Hawkeye STi misfire on cylinder 4 - help required
- 2nd knock sensor placement.
- gc8 330bhp oils
- injector upgrade
- Wastegate sticking open
- exhaust loudness help
- Please close
- Electrical gremlins after engine rebuild
- frontmount on newage
- restrictor pill location
- V3 STI inlet on 92 WRX RA head?
- Forge recirculating DV - worth it?
- Rough start
- cdf v5fuel rails
- Engine rebuild on blobeye,oil passing on cylinder
- 2.5" exhaust to 3" need a remap straight away?
- Classic TB exhaust on to a blobeye?
- gc8 v3 aftermarket camshafts
- newage owners......which fuel pressure regulator
- tapping
- Thinking Of Changing Gearbox
- headlight fit?