- ENGINE BAY TEMPS A BIT HIGH NEED SOME GOOD HEAT WRAP AND A TURBO BLANKET WHAT TO BUY
- Help with oil confusion
- heat wra which one????
- What gear box oil
- Sc40.. Will my sti5 take this turbo???
- Removing Stuck Caliper Pistons
- impreza sport coil pack
- Fitted a new MAF and now got CEL- code 23
- is this the right maf sensor??
- Can you put ignition on without ecu being installed?
- Panel filter oiling?????
- Hawkeye Aircon Pump Rattle
- So - I'm after an engine - advice and suggestions please.
- 12v socket dead
- Which plugs
- Power gains help please
- Turbo oil feed
- help!!!!high idle after fitting inlet manifold
- bugeye wrx ecu diagram
- not boosting over 0.8
- up-pipe improvements?
- 2007 wrx rattles and knocks ?
- Changing Cambelt
- recirc valve
- Modified V Spray Hi Flow800cc Phase Two Side Feed Injector Set
- Uk turbo 2000
- aps rotated setup any good?
- would you flush
- Struggling to know where to fit this resistor!
- ROCKER GASKET I.D ???
- Judder under deceleration
- DUMP VALVE / BOV HELP
- Help PLEASE :(
- Power steering pump failure on blob-eye
- how to turn off boost?
- Rocker cover
- Injectors
- Help with front number plate
- 1st subaru. What do i need to service it?
- new sump plug washer required on oil change?
- vibration on idle after ranting...
- Version 5 STi MAF Sensors
- How to feed through wideband sensor into area of ecu?
- Socket to fit....
- downpipe with slip joint, worth it?
- car died on way home
- Newage test mode connectors.
- central locking
- second hand ecu's
- Brian Crower cams
- Equal length manifold Questions??
- slow starting
- Fuel
- belt change help
- headers
- Top Mount studs not long enough for brace
- wagon and saloon
- Hi all Im new and could do with some good advice plz
- 0.5 bar boost and high idle
- Hawkeye STI Dash Clocks.
- remap reccomendations needed
- 2002 WRX STi type uk PPP - But TLC required... Suspension, Wheels & Tyres advice?
- Juddering when moving off
- Help Please Engine Light ASAP
- Odyssey battery terminals
- Manifold Spacers
- Opinions and part number wanted please!!!
- Advice on Block splitting
- Oil pressure
- Poor brakes
- 565cc injector question
- turbo transplant sucess!!
- Speedo problem
- Newbie probs
- Gapping
- HKS Oil Filters
- Rear drive shaft issue
- WHICH IS CYLINDER 1
- EJ257 Crank - Nitrided?
- Oil selection -Sustained high speed and high ambient temp
- legacy went boom today
- Reliabilty vs power
- Help please
- interchangeable interiors
- pcd adapters.