- p1 ecu
- Fuel cut.. all the time in 5th :(
- STi 6 - normal boost psi?
- Plug change help please !
- strange loud noise???????????????
- Rear Fog light conversion on STi lights
- Where is the fuse for the rear fog light??
- Oil Cath can fittings
- sidelights stuck on
- Air Con re-gas
- TMIC upgrade to STi v4
- fitting RA Roof Vent into WRX
- Pistons forged in STI 2006/07??
- error code 33 & 51
- header tank cap
- Apexi fc question
- Over tightened BOV bolt
- headers these any good ?
- Fuel Cut question
- heat wrap
- A Couple Of DIY Mods I'm Thinking Of Doing. Advise Please.
- Leak Help
- Second cat question
- Will this fit my 2002 WRX?
- 4 problems in just 24 hours :(
- THRUST BEARING?
- ECU change..
- Can anybody identify this HKS gizmo?
- revs drop when braking
- Head gasket thickness
- Newbie's Questions on back boxes
- Turbo Actuator Problems????
- Downpipe? Mid Section?
- a wee question??? (Eclipse)
- induction kit help.
- polar performance chip in sti
- exhausts
- witch backboxs
- flame
- sti 8 engine into a classic
- my02 decat uppipe or not?
- HKS Downpipe fluttering wastegate
- Subaru cant seem to fix my car
- Buying 1
- dump valve question
- Working oil pressures
- Automatic radiator
- My First Oil Change
- Arrgh FAULT CODE ON ECU Any Expertise On this Forum?
- Apexi power fc for My96/12
- need a/c electrical help
- 20% Off Denso, Purolator and Splitfire!!!
- Starting issue - please assist.
- Cam and crank sensors
- HEADERS
- g7 ecu
- Tightening door windows
- upgraded ecu
- Wing Mirror Replacement
- APS CAI
- i'm having trouble with my AFC controller
- Missing pipe
- Damn P0340 Fault Code
- Orange MAF air flow curve
- SHOULD I OR SHOULDN'T I
- Weird alternator issue!!!
- APEXi Commander Question
- Getting some bits from the US
- fitting cat bk on for mot
- V4 STI Maf Part Number
- paint code?
- Closed deck block?
- mayb problem with apexi commander....calling mappers..... tech people......anyone :)
- ECUTEK?
- Too small a lambda
- Need help with clutch
- dump valve mounted under vent
- anyone ?
- Methanol
- i get to 4500rpm and engine starts to lose power
- oil from dumpvalve???
- engine noise (video)
- what do i need to disconnect before welding
- help plz
- can anyone Help Please??