- 2007 Hawkeye blowing cold and coolant not leaving res.
- cobra subframe issue
- Suggestion for the next service
- Engine codes - dashboard lit up
- Clutch line
- EJ22G (22B) Blocks, new in their boxes!
- 2006 sti 2.5 coil pack
- Car cuts out randomly but then fires back up
- Cam Identification (v1 STI?)
- Starting Engine After 6 Months Rest
- Which side is what on the engine?
- DIY Pitch Mount Help
- koyorad or mishimoto
- Fuel smell
- Power issues
- ENGINE MOUNT ISSUES - IN GARAGE - URGENT
- Newage Chassis number / VIN
- Classic gc8 and newage wrx steering knuckles interchangable?
- What injectors do classic jdm sti 1997 have ?
- Plug gap
- Top feed injector conector
- Steering clunk when cold
- Ebay Silicone Tip any good?
- defi sensors
- Engine revving on its own!!
- Head bolt torque settings 2004 wrx Urgent plz
- Rusty bores - machining
- 2001 Impreza wrx turbo Exhaust header?
- Opinions
- EJ20k belt snap - all ONLY exhaust valves bent?
- Newage.rear subframe onto classic
- Project Classic Reshell
- Engine Running in
- Best oil to use
- Newbie with another turbo question :)
- sound proofing
- pro drive back box
- Classic parts fit blobeye
- sf5 jdm forester how many cats?
- Desperate.
- alarm location classic
- Refurbed lateral arms
- Bugeye upgrade injectors & vf35 should I change gear box aswell
- Cam cover gasket advice.
- Gearbox Rebuild Recommendations
- Small Bubbles in my over flow??
- Warped block?
- Best battery
- Rear of clocks KPH to MPH adaptor
- What turbo upgrade?
- VF35 rebuild
- intermittent start probs
- Car won't start
- Blowing exhaust gasket cause misfire?
- AC rad removal
- Front Bumper Scraping On Driveway.
- Headlight washer jet question
- H&S 3 inch Turbo Back Exhaust Opinions GRB STI
- Steam from under the bonnet
- con rods needed
- Neautral safety switch on classic gearbox
- Immobiliser locked out
- Engine not firing on one cylinder!
- Alarm or wiring Problem?
- Will it fit?
- Side exit exhaust - Classic
- PISTON TO WALL CLEARANCE MAHLE 2618 ALLOY HELP
- MY95 Impreza wrx cranks but doesn't start
- What garage in Coventry/ Midlands area.
- What recirculation valve for 2bar
- 2.1 stroker kit
- Lateral arms and bushing
- 2.5 STi HG issue question
- JDM newage defi speedo cluster......help
- Gauges - Fitting
- piston-to-wall clearance for Mahle EJ207 stroker pistons?
- Exhaust question
- GC8: BEST EARTH/GROUND . . .
- Cosworth induction kit
- Engine installation
- Help with defi gauge controller ID
- Hard race Gearbox mount pics.. Is it right?
- Rear Hub Backing Plates, interchangeable??
- EJ20 Heads
- How on earth do you weld a nut to a snapped bleed nipple on a Brembo?