- What is possible???
- Starting problems daily driver need help asap
- 03 Induction Hose fitting
- few pros advise needed
- Forged pistons
- td05 20g
- wrx intercooler into classic?
- wot induction kit with fmic?
- Anyone using mobil 1 MS 15/50
- overboost problem continued on my00 uk
- stainless steel exhaust
- A/F sensor location????
- Wiper Problem/question
- boost kicking in at high rpm
- PORTED HEADERS LESS ENGINE BREAKING?
- engine price
- Rustproofing
- lack of power at mid and high revs. Help.........
- Fitting STI intercooler on WRX - Is it easy?
- Ported headers
- Air Con Belt Tension
- 1993 WRX rev's but no acceleration
- 98 classic saloon interior would the wagon rear seat fit
- simtek???
- New Subaru owner, need help with a few questions.
- Wideband lambda with simulated narrowband...
- Idle problems
- gizzmo MS-IBC boost controller
- Head Gaskets - Recommendations
- Pipeing
- Radiator (will this fit)
- smoke on start up from cold
- 801/PPP or remap?
- GB 270 PCD
- cutting out after 4000 revs. help please?
- vf34 or tdo5
- Does a MY98 inlet manifold fit in a MY00?
- VF43 fitment on 07 WRX questions
- Problem - 09STI hopping at full steering lock?
- MY02 spec c engine-forged?
- Head Gasket AND clutch issues...
- re-build
- UPGRADE ADVICE
- scoobyclinic sc40
- does anybody know??
- wot turbo in uk spec car
- Classic 3 port
- will a 2.5 legacy bottom end fit my 1993 impreza?
- Starter motor or wiring problem?
- hybrid fmic help
- 97 classic will it be a v3 or v4 ?
- 3 port
- FxxK my head gaskit it gone!!!
- a map tweak
- 4 sensor showing a fault
- what do you think?
- will i need a remap
- ** 3 port boost solenoid help**
- Strange STIV4 dyno result/plot?
- help with shortshift
- will my car make 330bhp with this mods?
- New Owner
- Help with a leak ???
- maf position
- LIMP MODE..
- Turbo upgrade ?
- sti v5 turbo?
- paint code p1
- Closed deck Block
- Jubile clip came off !!!
- blitz nur spec R fitting 3" to 2.5" center??
- MINES ecu for type R
- hks induction kits
- engine light help please
- front mounted turbo
- What BP gains will i get from these
- clutch or gearbox
- checking actuator
- new age clock
- where do get a 3 holed oil catch tank for a newage
- fitting a fmic
- Headlight washer removal
- 98 ECU - Apexi, Simtek or ESL solution??
- Insurance repair = headache!
- Engine issue