- What kind, and how much wrapping for headers and up pipe?
- Anyone used/using exedy hyper triple plate?
- Md321T Billet with sti pink injectors ???
- Handling!?!?
- Service in North-West
- Where's my engine number? (Please)
- Will a a triple gauge pod from a 98 impreza turbo fit my 2000??
- Blobeye shocks on a Bugeye
- impreza/legacy gtb cross compatibility
- Ecu
- Tuning for maximum response/torque
- West Yorkshire imprezza specialist needed.
- Some thoughts please...she's just not right..
- 660 injectors ???
- Converting Side Feed set up to top feed.
- 2002 Impreza engine swap EJ20
- Wanted Set of Lowering springs for a Newage WRX (Bugeye) Wagon
- help with hks turbo timer please (handbrake wire) 2003 STI
- Would 2000 wrx inlet manafold fit a 2005 wrx?
- Head Gasket, Worn or not?
- Whiteline Front Of Rear Diff Support
- Any tips on passenger airbag removal?
- Odd overheating problem
- Will RCM headers mate with Japspeed 3 bolt up pipe?
- Stood Subaru oil leak
- Another problem with engine
- Exhaust/Mapping Advice
- eBay bov
- what is this part????
- Con rod install direction
- wheel bearing?
- Replacing Turbo intake hose
- Raising the Height- Do I need to do the geometry again?
- limiting factors of a v4 wrx type r?
- Hawkeye forged from standard???
- Brake Discs
- 4L ecu
- leaking gasket ?
- 2003 sti diff
- New Impreza Sport Premium owner
- Subaru impreza wrx 2005 overheat
- Hatch sti owners !! What exhaust you running
- Speedo Slightly Out
- Heads-up Millers 5w40 £18.53 5 litres!!
- Titanium head studs?
- impreza 2.0d RX exhaust
- Piston ring gap ej20g
- brake discs
- Colour code for Type RA
- Perrin turbo heat sheild
- What's my best option?
- Confused with which spark plugs
- 2003 wrx main bearings?
- Closing bonnet with damper rods fitted?
- intercooler pipe size
- Induction panel filter?
- Perrin turbo inlet hose
- Innovate Mtx-L wideband issue.
- v2 sti air box question
- Whats this plug for??
- Testing recirc
- 11 Year Service? What is required?
- Short Block Swap
- v3 to coil on plug conversion
- Which parts for classic engine...
- Cracked cylinder head
- Drive-fan belt pulley???
- BHP estimate please guys
- Blob eye scoop fixings
- spot the difference?????
- Help please
- Brakes bleeding, Eezibleed
- help needed
- What's my car worth?
- Rough idel no wont start
- PCV Valve? Update: Ringland :(
- Oil dipstick seals....is this right?
- Uprated actuator
- fmic help
- Choosing the right turbo, TD04 VS TDO5
- Limp mode problems
- Inner Driveshaft Boot
- Occasional fuel cutting issue
- how much to replace a gearbox?
- New TD05 going on today