- New clutch needed, what should I do?
- STi Anti Surge Fuelpump assembly pictures
- Exhaust and Warrenty on a STI7
- Induction Kit / Performance Mods
- exhaust???
- Oil
- PPP TO motec ? ecutek ? link ? gems Or something else ????
- Using the WRX EGT probe ?
- How to clean inside of exhaust to make it louder?
- Clutch Rattle?
- Dawes Device P1
- The new gearbox that was tested
- Newbie Exhaust Question (STI 4)
- Speedo cable
- Overheating
- STi V Type R crunching into 5th
- Rattling exhaust shields
- 3 port solenoid
- Why would an HKS EVC IV be better than a bleed?
- clutch smell?
- Anyone made a CHARGE COOLER?
- CLUTCH
- Poll - Does removing the downpipe cat in a MY01 make the car run cr@p?
- Spark plugs and performance
- Quickshifts
- sparky!
- Specs of STi3
- De-catting a MY01 BUT leaving the downpipw cat in place
- How loud is yours
- Emissions ok but failed MoT.....
- Changing Gear Question
- Universal Turbos in Dorset
- Help on Fitting New Exhaust Backbox
- Max flow of the OEM center cat??
- Anyone got their EGT probe in the downpipe?
- Butchering sti exhaust good idea?
- for john banks
- What is the best - HKS vs APS
- Inlet pipe problems
- Afterburner rear silencer
- anyone know a good place to get DPand mid section?
- Difference Type R & V-Ltd (Gear Ratios)
- Deep cryo treatment for parts
- Where to put sensor for egt??
- MOT fail High CO reading --- Help
- Strange responce.
- Whats a dump valve?
- New Scoobysport
- Clutch pedal problem
- Knocklink readings help....... please.
- Any way to remove imobilizer on 1999/2000 WRX?
- How many....
- Which gearbox and diff oil?
- Uprated Clutch
- EBC Performance clutch..anyone used one?
- Q8 super unleaded
- Downpipe!
- Induction Kit
- Whats needed to run 1.5bar??
- Tuning parts for Legacy 1.8 FWD
- Opinions on this dyno run?
- VF23??
- Advice on Exhaust System wanted
- 2 error codes from ecu
- Exhaust systems
- Why's my boost climbing after levelling??
- Knock Sensor
- 2.2 legacy convertion to a wrx impreza
- Inlet pipe suggestions please
- Tek3 for MY02...with lots of mods
- EcuTek STI7 UK Re-Map @ Power Engineering
- Poject XXX is go!
- LSD?
- Which mods for EcuTek 2 remap?
- Manual adjusting rich mixture on legacy
- Tim built Up-Pipes
- Bolt torque for flywheel & clutch
- Downpipe backpressure question
- blitz b/box
- p1
- Downpipe without back box?
- Prodrive BB
- Need Help,Please engine cut out with decat,my01
- Juddering clutch - Are IM bringing out an ugraded clutch?
- *~*~Tuning bits for sale*~*~