Im looking to fit a wideband lambda sensor and gauge and was hoping that i can use the hole that the narrowband one is in.

ive seen some kits that have a simulated narrow band output, would this work in place of the normal narrowband sensor for the ecu?

also what kits are good?

Cheers
Rich

 

i have my lc-1 installed like this, had to diable CEL for the heater wires tho, there is something you can do with a resistor/capacitor to prevent this if you dont have access to a mapper / tactrix cable

 

Have a look on Dynotune and Innovate for WB02 with simulated signals.