- 94 v1sti speed sensor wiring diagram
- Test mode not working. Boost solenoid very quiet?
- Remapped E3 ECU
- Tried to connect Link MY99 to Laptop-Car wont start
- position of aftermarket fpr with tmic fitted-blobeye sti
- tuning
- Testing 05 wrx coilpacks off car;which terminals?
- t/body coupling hose with iat sensor hole
- ESL Fuel Trims - Gasket leak?
- sensor-iat? where to get/what spec
- RB5/ Impreza Turbo GT Series II parts/ecu compatibility
- Fuel pump
- Any had esl mapped by pro
- external wastegate/screamer-manifold?PIC ADDED NOW
- decat or not decat?
- Best entry level data logger
- Knock detected but not heard
- ring land blown on fresh build..
- Gloucestershire
- jt ino loom
- lambda sensor
- Which ECU?
- Can anyone confirm this as a prodrive Ecu?
- anyone got andrew carrs number
- Prodrive Remap with MBC @ 16/17psi
- Cel and timing ?
- Jdm blobeye iat sensor fitted to tmic is a map tweak needed.
- We are on Kickstarter! Device for vehicles!
- lack of power
- Header and exhaust wrapping??
- A good day at enginetuner
- ESL mapping course.
- Mapper in Sussex
- Remap
- ECU Remapping
- Fuel pressure regulator or fse boost valve?
- Exhaust and Remap
- OEM TMIC vs STI intercooler
- TMIC & FMIC
- Remapping standard blob sti
- P0335 p0031 help
- Rear o2 sensor code problem.
- Wastegate flutter / Overboosting
- Max boost
- hesitant acceleration under light throttle
- rad and bracket changeout
- Put cats back on, do I need to map again?
- WRX Hawkeye Mapping Debate. Who do I go to? What do I need?
- TD05/06 20G/16G?
- Mapping in a 3 port bcs advice
- Only 403bhp on md321t
- Manual Boost controller with prodrive ecu
- trigger issues. not able to rev past 6600rpm
- Effects on the engine?
- Had my car mapped 😁😁
- torqe development international ESSEX
- Prodrive ecu code 97
- Uk2000 prodrive
- Heater In and Out Pipes
- TB's and Inlet manifold newage differences
- Anyone got a Billet GT30r on 2.1ltr?
- After new cam belt engine managemnet light is on
- 4 or 5 plug ecu
- Engine light on after sports cat
- 98 topfeed conversion fuel supply problems
- Andrew Carr remap
- Delving into the ECU
- sg9 ecu pinout required.
- I APPRECIATE THAT
- Couldn't get turbo to boost on remap
- rcm rotated 3082 kit
- Throttle sticking blobeye
- I'm new to mapping so any help?
- blob eye over boosting issue
- dump valve problems
- Meth?
- Where to get my car mapped?
- FFS More CEL issues
- Problem with boost only 0.5 BAR sometimes
- bee r not working help please
- 99 STI boost?
- P0031 then P0134 - blobeye
- unlocking Alcatek features
- OBD2 tracker and scanner
- New car new problems - alcatek