- Version 6 Simtek wiring question
- Jdm gc8 v5 sti with vf28 359.6bhp BY RACE DYNAMIX
- mapping JDM import for UK fuel?
- Remap with just cat back exhaust
- V1 Classic ignition timming retarding
- Second Cat... Remap?
- 2005 blobeye wrx map advice
- Can an ECUTEK map be altered??
- Orange Label Maf for Classic Scooby
- Remapper in South Wales needed
- Ej15 turbo
- 96wrx remap advice
- Help coolant header tank
- Air Filter/Induction kit
- 2000 impreza turbo tuning
- Dumpvalve question
- quick prodrive ecu compatability question
- Fitting a dump valve - 2005 blobeye wrx
- Question for Mappers - Mapping Other Cars
- help with vw t2 campervan
- What is this white wheel??
- Ecutek still best option for 99 classic
- Do i need to uprate my plugs for remap?
- Any apexi ECU gurus out there?
- Dyno / Remapping in South / Mid Wales
- Alcatek info please
- actuators and spring rates...explain...
- cheap bov
- Wiring wideband to Alcatec ecu
- mapper in norfolk required
- open cone filter
- Changing coolant 2003 wrx sti
- Closed loop and narrowband sensors
- Wideband AFR vs Fuel map
- new engine fitted, now fuel pump is dead?
- Pre-map mods for 350BHP
- Avcs help
- HELP HELP MAPPING
- Good garage near London
- ECU remapping for AlcaTek near Berkshire
- power fc
- P1 keeps cutting out !
- Powertrain system too lean 😨
- mobile remapper nottingham ?
- Uprated fuel pump
- Removing Pins from ECU Connector
- jdm impreza sport ej20e sohc ecu pinout
- apexi PFC repair ?
- Cel light an low idle cold
- Fault codes
- Spark plugs when to change them!!
- advice needed, check engine light in traffic
- Battery disconnect and ECU reset
- Prodrive ecu for my00 classic
- Newbie help - CEL and no boost
- Rough idle after ecu reset
- 2.0L Blobeye PPP with VF34 - disappointing results
- Poor hot starting 330s
- engine management light
- Simtek Upgrade to Alkatek
- forester sti mapping
- New STI - Bricking it.
- Software for logging
- Apexi AVCR revs reading low
- Bluetooth OBD fails
- ESL maffless help
- Good place to buy ESL
- P1 - Lambda sensor connection to loom
- Y7 pin arrangement
- Simtek ECU from Jap import WRX STi into UK WRX
- Anyone have a 2004 Forester xt engine for sale?!?
- OBD2 help.
- Professional det cans
- P0420 Fault code immediately after fitting Prodrive full exhaust
- Engine/mapping help
- How to map recent purchase with Simtek ECU
- Ecutek Ecu
- Fault code reading.
- nitrous which ecu is best?
- Apexi reads 0.0V on lamba
- New engine... Running in map??
- power tolerance diff open/closed/semi deck block
- gentle boost AFR
- Couple of questions on ESL
- Error code PO420..Could it be the sportscat?