- delete this one wrong section.
- Misfire on cyl 3&4
- ESL Daughterboard A/L?
- Esl board removal
- Remap time
- alcatek & lambda sensors
- ECUtek or Alcatek
- Exhaust for a NA Scoob
- Ecutek, not tweakable by others?
- Dyno map prep..
- Need help
- Additional sensors for Alcatek ecu
- Remap after decat
- Engine Rebuild Time
- MY99-00 prodrive ecu
- 320r mishimoto intake?
- 2003 wrx map
- STI - What to do next???
- PPP
- anti lag system hardware?
- Any mappers who can map my 99 forester stb manchester
- Exhausts
- Alcatek vs ESL
- Remapping a Standard WRX
- Toyosport decat? Any Good?
- ecutek data monitor help!!!!
- ecu reset problem
- My dealings with Alcatek.
- AFP 04-H custom ported hybrid turbo
- ECU Help
- wrx remap in essex (advice please)
- Rom performance
- 5th gear synchromesh problems can i still dyno map
- not starting when hot
- evotune remap results
- >ESL<
- UK300 and my WRX
- Who's the best man ?
- Didn't think a Sports cat needed a remap?
- EJ25 Open Deck 500BHP Max Power Boost Strength Capabilities
- not boosting over 1.1 bar
- Dump valve question
- Engine rebuild
- Remap
- Flywheel and Mapping
- Second Hand Alcatek
- Where to mount IAT sensor for going MAFless
- anyone had there scoobys done at evotune
- 2008 sti ringland failure costs
- which maf
- 3 port solenoid
- Boost control
- Wrx PPP map
- Need more power
- Polar Performance Chip
- Apexi ECU - Testing
- Traction control on a dccd car
- Base map
- scoobyecu info needed
- maf cleaning
- Will phase one injectors fit phase 2 rails ?
- Any ideas what EBC this is?
- Will I need to upgrade my MAP sensor?
- scoobyecu.co.uk
- Help a Newbie! Remapping PPP ECU?
- esl and toucan
- Z4 ecu question
- What selector switch are you guys using (alcatek)
- Boost drop
- Need a map, who shall I use?
- What else is required? Fitting AVCS heads to m 99uk
- 2001 Forester S/Tb STi II Cold Air Intake
- Maf to map conversion
- CEL lamba problem
- Remap needed...again??
- Can someone answer this please
- boost solenoid
- Good mapper in the South West?
- 330s - Remove PPP
- PFR7B or PFR6B sparks for WRX 05 ?
- Ecu upgrade
- little info please?
- Won't start after inlet manifold replace
- Couple of self mapping questions
- Remapping a version 5 sti import