- Sti clocks in turbo 2000
- Exhaust remapping advice
- Standard Uppipe Replacement
- downpipe on hawkeye same as earlier new age ?
- Will changing Blob C frame require alignment?
- Identify the rusty part, and the mysterious lock.
- lamco bulbs
- MY11 STI saloon noise on cold start
- jdm electronic spare key
- hawk sweeping dash to a widetrack dash?
- Oil usage
- Help with front propshaft
- ACL race bearings Vs King race bearings
- Misaligned wheel
- Read thrust or centre
- GX exhaust
- Car History Check
- Bubbles in matrix finally sorted!
- Front cross member
- Newage Intercooler dump valve flange
- Engine fault code reader
- super loud pipes newbie
- What grinder disc for underbody
- Kmh to mph conversion Hawkeye STI
- 330S Rods
- Mot question
- fuel smell through heaters
- Oil temp gauge changes when I turn headlights on please help
- What are these ?
- New discs fitted slight noise when on full lock
- Can someone please explain this (Cambelt with photos)
- Defi
- bodywork guru,s help!
- BRAKES PADS
- Decat remap
- Replacing cambelt tools.
- V4 or v5 (best parts to use)
- Just oil cooler or oil + rad?
- P0031 where is front O2 sensor on jdm blob
- Rotating and holding Cam Gears to reinstall Timing Belt ?
- Rcm induction kit silicone pipe size?
- FMIC Pipe Clips
- Help needed, bugeye bonnet won't open
- Size of headers gaskets??
- Do I have a big problem????
- Engine swap back to standard ??????
- WRX Hawkeye Loss Of Power
- Fitting used injectors.
- nitrided or heat treaded stock crankshaft
- CDF PAS pulley nut torque?
- injector connectors / plugs
- ABS light on any ideas
- Jdm fuel filter
- What Gaskets required please!
- advice needed
- Quiet 3" exhaust for a newage sti
- Engine will turn but won't run.
- 1999 subaru impreza gc8 fog light mounts
- Buying a blobeye WRX, Leaking fluid underneath?
- v2 front entry conversion injectors set up
- noise when clutched depressed
- sti typeuk 1st gear issues
- Where the hell are the cam sensors on a Hawkeye WRX????
- Only Subaru coolant?!
- Squeaking clutch master cylinder
- Milltek 3" Twinscroll downpipe fitment
- Correct O2 sensor for blob SpecC
- Engine breathing heavily from catch can
- Sti clock milage change
- Thoughts & comments on my DIY weldless TGV delete solution before I fit them?
- Just a quick one!!
- Newage arch rust - suggestions
- Impreza hatch tailgate
- Built engine refresh
- Flo-Flex drop links. Imperial size?
- new turbo
- 3 port solenoid
- Sti Prodrive sports cat questions
- will an upgrade to an sti tmic be overkill for my setup-04wrx
- standard head gasket thickness on a 2003 wrx?
- Larger capacity radiator
- SSI headers...GT spec??
- Some tips for fitting silicone turbo inlet hoses
- Hi new Essex scooby owner
- Hi newbie here