- switching off and engine rattle
- MY00 cats
- Oil change
- Cheap De-restictor
- MY02 Prodrive WR Silencer
- Induction kit DROPS torque!!!
- It's official Big end No 4 gone
- ???I want a louder back box ???
- ITG air filter
- Dumb-arse IC question.
- down pipes. open neck v twin dump
- Gear ratios?
- fuel type cause over boost
- maf
- MY00 Hesitation
- What can i do for 6 bhp more?? Reasonably cheap
- MAP sensor failure - cost? Help please.
- Downpipe swapping Wigan/Manchester
- MY02 Tranny Grind?
- Legacy B4 - cats, turbos, intercooler, big power
- which is the best oil?
- Prodrive ECU vs Std ECU at same boost
- BOOST GUAGE
- Is an EBC gonna achieve as good results as the Dawes
- P1 Boost pressures
- Bloody car !!!!!!!!!!!!! Heeeelllllllp
- Power Steering whine
- Power Steering whine
- www.superchips.co.uk
- Changing Manual-Gear Oil (and bad shifting)
- I want more boost...........
- Hesitation Fix ?
- ECU wire resoldering + CEL reset MY01
- Electronic boost controller project
- Tanabe Exhausts?
- engine conversions
- Is this Overboost ?
- Mobil 1
- Oil Gallery No. 3 Adaptor Part Number please...
- Are all MY Knock sensors the same ?
- £12.50 AFR Fitted in MY94
- Cluth fluid 'overflowing'
- Should I fit my LINK and Blitz filter?
- remove resonating pre filter in wing?
- Silly Gasket Question
- ScoobyMania A pillar pod and Defi gauge pics....
- An apology to PPP onwers!
- Select Monitor parameter address / converstions
- Drive belt noise
- Recommendations GEMS & LINK Mappers????
- ### Rolling roading a Type RA ###
- Coils, where are they?
- MY01PPP experts, please help.
- Calling John banks or HarryBoy
- Why exhaust temperature??
- B+M quick shifts
- What inlet temps are you FMIC boys running?
- Oil (again!)
- Exhaust and Equal Length Manifold
- Rampod Air Filters
- Big end failure - cost breakdown...
- MY01 STI Boost Routine
- octane boosters
- MOT's & midsections - 99MY cars
- Is a VF23 still the turbo of choice?
- CLUTCH
- uprated conrod bolts
- Engine Oil - Links Plz
- Electronic Diff ECU ??
- I'm changing my brake pads tonight, can anyone tell me how to do it?
- Time estimation ? P.Croney and others
- Bloke at work has filled his petrol car with diesel oil
- Is it worth getting a flexi jointed up pipe for my01 wrx
- exhaust manifolds ported
- Exhaust Manifold Porting
- FAO Tek2 people, whats your opinion on it
- Knocking noises
- MAP Sensor - Help Needed!!!
- Piston slap, general question.
- Engine Difference between Legacy Turbo and Imprezza Turbo
- KnockLink on a (near) standard STI7
- K&N Panel filter
- 412 Wheel HP on STI V7 2.0 with LINK
- Dump Valve Fitting Kit - How Much ?
- Worrying oil drip from flywheel area??