P1 box fitting
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jan 2006
Location: N.I
Posts: 480
Likes: 0
Received 0 Likes
on
0 Posts
P1 box fitting
Just fitted a P1 box and Matching Diff into my 93 wrx and when fitting the drivers side shaft into the p1 diff using my orginal shaft it doesnt fully go into the diff so the clip can be fitted yet the passanger side fits perfectly.
Theres no travel in the shaft so dont think it will come loose but is this normal for this conversion or have i missed something i should have done?
Cheers
Drew
Theres no travel in the shaft so dont think it will come loose but is this normal for this conversion or have i missed something i should have done?
Cheers
Drew
#6
Scooby Regular
iTrader: (3)
Join Date: Oct 2007
Location: newtownards
Posts: 1,002
Likes: 0
Received 0 Likes
on
0 Posts
is this the rear you are talking about or the front?
When i was putting my PPG box in it used a P1 rear diff and i had to use P1 rear drive shafts, my standard ones fitted inside the diff just wouldnt click in.
You will need to get P1 rear drive shafts. ths front ones should be ok AFAIK
When i was putting my PPG box in it used a P1 rear diff and i had to use P1 rear drive shafts, my standard ones fitted inside the diff just wouldnt click in.
You will need to get P1 rear drive shafts. ths front ones should be ok AFAIK
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM