Hi all

I have a Innovate mtx wideband that I want to wire to my Alcatek ecu.
Ihave been told by Andy that this can be done but does not recall how.

I want to use the serial plug on the wideband but it has an in and out but not sure which one to use or how to wire this into the ecu.

I have the programming kit for the Alcatec and can select the Innovate serial protocol.

So all im after is some wiring tips on this, if anyone has done this or can help i would be very grateful.

Thanks.
Kieron

 

Someone must of done this.

 

brown wire if you want it to simulate a narrow band output
yellow wire if you want the wideband output

on the ecu i assume it will just go to the original o2 input signal pin

 

Thank you but that's how I had it wired up before,
When I sent the Ecu away to have it upgraded from Simtek to Alcatek Andy told me to use the serial link as it's faster but he couldn't recall how to wire it.