Pre-map mods for 350BHP
#1
Pre-map mods for 350BHP
Hi everyone.
I'm getting close to the point at which I am happy to fork out to get my 1998 Terzo mapped.
After lots of research, I am going to go down the ESL route (I think) and I am hoping to hit around the 350 mark.
My supporting mods are :
STI TMIC (with appropriate bonnet scoop & undertray)
Apexi Power Intake Induction Kit (with cold air intake from brake duct)
Walbro 255 fuel Pump
Yellow 440 Fuel Injectors
Reconditioned TD05 16g Turbo
Full SS Blitz Nur Spec R Turbo Back (heat wrapped)
My question is whether any of the mods listed will hamper the target of 350BHP?
I.e. Will I be better of with bigger injectors?
Or, will I need a decat up-pipe?
Thanks.
I'm getting close to the point at which I am happy to fork out to get my 1998 Terzo mapped.
After lots of research, I am going to go down the ESL route (I think) and I am hoping to hit around the 350 mark.
My supporting mods are :
STI TMIC (with appropriate bonnet scoop & undertray)
Apexi Power Intake Induction Kit (with cold air intake from brake duct)
Walbro 255 fuel Pump
Yellow 440 Fuel Injectors
Reconditioned TD05 16g Turbo
Full SS Blitz Nur Spec R Turbo Back (heat wrapped)
My question is whether any of the mods listed will hamper the target of 350BHP?
I.e. Will I be better of with bigger injectors?
Or, will I need a decat up-pipe?
Thanks.
#3
Scooby Regular
iTrader: (1)
I made 350bhp on my p1 impreza with hrc fuel pump, cobra sports cat, p1 stamped exhaust, and no other mods (Standard vf28 turbo). I did have the injectors cleaned and flow matched though. Cobra Cat only lasted 2 mot's before failing! Oh and shortly after mapping had to change to pink box exedy as well!
Last edited by Chrisp11981; 17 May 2015 at 10:14 PM. Reason: more info
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM