disaster
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: May 2008
Posts: 466
Likes: 0
Received 0 Likes
on
0 Posts
disaster
Me and a friend started removing my engine from the car this evening. Got the engine nigh on ready just the gearbox to unbolt when my monkey of a mate some how managed to snap the m6 bolt that you screw into the clutch fork to remove it. i tried getting the pliers on it but no good as there is about half a mm to grab what a nightmare.
any body got some ideas
any body got some ideas
Trending Topics
#8
Scooby Regular
Join Date: Aug 2003
Location: Sheffield; Rome of the North
Posts: 17,582
Likes: 0
Received 0 Likes
on
0 Posts
#9
Remove the rubber cover around the clutch fork, and try using some long nose plyers to push the piveot bar through, put some WD40 around the piveot bar.
If you score the surface doing it, just polish it off with some wet and dry
If you score the surface doing it, just polish it off with some wet and dry
Thread
Thread Starter
Forum
Replies
Last Post