disaster
Me and a friend started removing my engine from the car this evening. Got the engine nigh on ready just the gearbox to unbolt when my monkey of a mate some how managed to snap the m6 bolt that you screw into the clutch fork to remove it. i tried getting the pliers on it but no good as there is about half a mm to grab what a nightmare.
any body got some ideas:wonder: |
try to weld something to it
|
drill and tapp it?
|
i was going to try welding a nut to it. if not im going to have to drop box and engine out together and drill out.
|
id sack your mate and have sex with his sister/mother/girlfriend/wife/significant other:D
|
Originally Posted by chocolate_o_brian
(Post 7995042)
id sack your mate and have sex with his sister/mother/girlfriend/wife/significant other:D
|
Originally Posted by chocolate_o_brian
(Post 7995042)
id sack your mate and have sex with his sister/mother/girlfriend/wife/significant other:D
|
Originally Posted by chocolate_o_brian
(Post 7995042)
id sack your mate and have sex with his sister/mother/girlfriend/wife/significant other:D
|
Remove the rubber cover around the clutch fork, and try using some long nose plyers to push the piveot bar through, put some WD40 around the piveot bar.
If you score the surface doing it, just polish it off with some wet and dry |
drill a left hand thread drill bit in to it should lock in side th bolt and un do it
|
Originally Posted by Phildodd06
(Post 7995095)
Remove the rubber cover around the clutch fork, and try using some long nose plyers to push the piveot bar through, put some WD40 around the piveot bar.
If you score the surface doing it, just polish it off with some wet and dry |
All times are GMT +1. The time now is 11:12 PM. |
© 2024 MH Sub I, LLC dba Internet Brands