WHAT POWER AM I RUNNING?
#1
WHAT POWER AM I RUNNING?
aint got that many modifications.... but yeah
my car is a 1993 wrx mods are
td05h turbo (running 1 bar)
k&n induction kit
full through decat exhaust
iridium sparkplugs (if these make a difference)
WOULD IT BE AROUND 270ISH?!?
my car is a 1993 wrx mods are
td05h turbo (running 1 bar)
k&n induction kit
full through decat exhaust
iridium sparkplugs (if these make a difference)
WOULD IT BE AROUND 270ISH?!?
#2
u can get power runs cheep at scooby clinic at the mo and there are other places too such as scoobyworld. if u do that u will get a graph and loads of advice to boot
#6
thanks mate...and yeah ive been told to only run it at 1 bar max as to run it at any more i would need forged internals or i will blow the engine...so id rather be safe than sorry lol, also no remap yet but im going to buy a z4 ecu.
#7
with your car i would not bother with the z4, depending on funds, get either a chip or a esl live map board, and go from and as for the internals as long as it has been maintained well it will be ok.
Trending Topics
#8
Scooby Regular
Join Date: May 2007
Location: By t'canal in West Yorkshire.
Posts: 344
Likes: 0
Received 0 Likes
on
0 Posts
'hope this helps
#10
Scooby Regular
iTrader: (8)
My 93 has standard internals and was mapped at 1.5 bar peak by Mr Forrest himself. Granted thats with the appropriate supporting mods.
Yours probably is around 280 with a mines, but you absolutely must run 99 ron fuel and would be better with a less aggresive map.
#12
#13
Scooby Regular
Join Date: Dec 2002
Location: Sunny BELFAST
Posts: 19,408
Likes: 0
Received 0 Likes
on
0 Posts
Why are people so obsessed with BHP figures. Bragging rights down the pub? what difference will it make?
Thread
Thread Starter
Forum
Replies
Last Post
hedgecutter
General Technical
3
25 September 2015 02:35 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM