ZANY

As above I would have bought it if I didn’t have spare ones allready !

https://www.ebay.co.uk/itm/293710566989

ray54

[[b]QUOTE=ZANY;12088666]As above I would have bought it if I didn’t have spare ones allready !

https://www.ebay.co.uk/itm/293710566989[/QUOTE]

Spare ones many you got!?

ZANY

I’ve got full replacement should mine go and also a brand new lamco gauge kit if I or the future owner wishes to change it

domino46

do you have the full set ? ,, my WR1 came with a full set of 4 so I was well happy ,, oil pressure was playing up but iv managed to fix it luckily lol

RobsyUK

iTrader: (2)

my oil temp has just started playing up. Is there a way to test the sensors?
although, I've swapped everything with water teml and get the same fault.
sweeps on start up then just flashing light and no reading.

ZANY

yes mate I have the full set branded

but I’ve kept the middle ones to one side don’t want to be messing with sandwich plates etc I never drive it hard enough and it’ll just make me paranoid to be honest the clocks just fine

i even had a brand new psi3 monitor with instructions etc ended up selling it as the last one just made me paranoid
boost one is ok maybe I’ll ad a twin pod were I fancy putting the water temp on sometime in the future 😂

domino46

mine was a loose back connection ,, wouldn't work unless it was pushed in and held there so I made something up to do the job and hold it in place

domino46

iv also got a spare psi3 sat in the cupboard with the original dash top pod lol good things to have around just in case they are needed lol