Alarm problems on a mk2 mondeo
#1
Scooby Regular
Thread Starter
Join Date: Dec 2001
Location: just simple old me
Posts: 2,170
Likes: 0
Received 0 Likes
on
0 Posts
Alarm problems on a mk2 mondeo
Got intermittant alarm probs on my mk2 mondeo-i'll go a journey and park car and sometimes after being parked for 10 minutes the alarm will go off for no reason-i will then turn alarm off and wait a while-re-arm it and its fine-have read on a mondeo forum that quite often the bonnet pin switch plays up, so i disconnected that and tested that with a multimeter and it tested fine- but still alarm is playing up occasionally-any idea's?
#2
Scooby Regular
iTrader: (3)
Join Date: Aug 2000
Location: 1600cc's of twin scroll fun :)
Posts: 25,565
Likes: 0
Received 2 Likes
on
2 Posts
The only way around it is to lock the car manually (yours a 97 onwards with the plip remote?)
That should overcome the problem but you wont have the alarm active (but the immobiliser will be).
Tony
That should overcome the problem but you wont have the alarm active (but the immobiliser will be).
Tony
#3
Scooby Regular
Thread Starter
Join Date: Dec 2001
Location: just simple old me
Posts: 2,170
Likes: 0
Received 0 Likes
on
0 Posts
been thinking about it last nite-and it only happens when the passenger door has been opened-so im thinking must be a dodgy connnection on that door.
#5
Scooby Regular
Join Date: Dec 2005
Location: In general, generally generic.
Posts: 329
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by ^OPM^
been thinking about it last nite-and it only happens when the passenger door has been opened-so im thinking must be a dodgy connnection on that door.
Tap your bonnet pin switch 10 or so times to enter diagnostic/test mode (once you've reconnected it ). The horn will briefly sound when it goes into diagnostic mode and every time you trigger a sensor. So you can check each door/boot etc.
After 30seconds of inactivty it will exit diagnostic mode giving a double beep on the horn
#6
Scooby Regular
Thread Starter
Join Date: Dec 2001
Location: just simple old me
Posts: 2,170
Likes: 0
Received 0 Likes
on
0 Posts
will do this next time i get chance-thanks
Originally Posted by Generic User
Tap your bonnet pin switch 10 or so times to enter diagnostic/test mode (once you've reconnected it ). The horn will briefly sound when it goes into diagnostic mode and every time you trigger a sensor. So you can check each door/boot etc.
After 30seconds of inactivty it will exit diagnostic mode giving a double beep on the horn
After 30seconds of inactivty it will exit diagnostic mode giving a double beep on the horn
#7
Scooby Regular
Thread Starter
Join Date: Dec 2001
Location: just simple old me
Posts: 2,170
Likes: 0
Received 0 Likes
on
0 Posts
been out in car today with a passenger-drove for 15 mins parked up-no false alarm-then drove another 4 miles and alarm goes of for no reason-i then got passenger to only use back door then-drove for another 15 mins and still alarm then gives false alarm-did this twice then-then it worked ok again-so about an hour later i did the alarm test and checked every door etc and bonnet and everything shows up as ok-could it be the heat getting to the bonnet pin switch?
Trending Topics
#8
Scooby Regular
Thread Starter
Join Date: Dec 2001
Location: just simple old me
Posts: 2,170
Likes: 0
Received 0 Likes
on
0 Posts
As far as i can tell my car hasn't got interior sensors so air moving inside car shouldn't set alarm off
Originally Posted by TonyBurns
Could be a door seal?
These are volumatic aint they? (should really read my mondeo manual )
Tony
These are volumatic aint they? (should really read my mondeo manual )
Tony
#9
Originally Posted by ^OPM^
been out in car today with a passenger-drove for 15 mins parked up-no false alarm-then drove another 4 miles and alarm goes of for no reason-i then got passenger to only use back door then-drove for another 15 mins and still alarm then gives false alarm-did this twice then-then it worked ok again-so about an hour later i did the alarm test and checked every door etc and bonnet and everything shows up as ok-could it be the heat getting to the bonnet pin switch?
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
toyney83
General Technical
10
02 October 2015 08:38 PM