blown a 50amp fuse - help please
#1
blown a 50amp fuse - help please
98 classic sti, import v4.
I was fitting my new flocked under dash last night and it was all going great.
However, I must of touched, dislodged something or other as when I went to start her up I had no igntion lights.
So, I opened up the fusebox to see that a 50 amp had blown.
I replaced it, but it blew again as soon as I turned the key, so I obviously still have a fault somewhere.
Problem is though, that I have had the dash apart again and I cant see anything that I have coupled up incorrectly, any broken wires, etc etc
Can anybody lend me some assistance, otherwise car is off the road and I only just got it back from getting the oil leak/timing belt done
Would really appreciate your speedy help folks. Plus anybody that could mail me a wiring diagram that would be good too.
I was fitting my new flocked under dash last night and it was all going great.
However, I must of touched, dislodged something or other as when I went to start her up I had no igntion lights.
So, I opened up the fusebox to see that a 50 amp had blown.
I replaced it, but it blew again as soon as I turned the key, so I obviously still have a fault somewhere.
Problem is though, that I have had the dash apart again and I cant see anything that I have coupled up incorrectly, any broken wires, etc etc
Can anybody lend me some assistance, otherwise car is off the road and I only just got it back from getting the oil leak/timing belt done
Would really appreciate your speedy help folks. Plus anybody that could mail me a wiring diagram that would be good too.
Last edited by ANDY597; 11 July 2011 at 09:39 PM.
#3
Thread
Thread Starter
Forum
Replies
Last Post
toyney83
General Technical
10
02 October 2015 08:38 PM
Adam Kindness
ScoobyNet General
0
15 September 2015 03:31 PM