pauld37

Which pipe do I cut to fit the T piece for the tubing that fits to the gauge?



Its an MY01 WRX Bugeye

Thanks Paul

alex_00s

iTrader: (18)

See the red circle over the dump valve? This be where mr T piece should be joined!

pauld37

Cheers mate, is the gauge tubing in that photo going off to the left?

RON

I thought you were doing your springs Paul..... mind you, it is wet!!

pauld37

Will be doing them tomorrow Ron if its dry .....and managed to fit this

alex_00s

iTrader: (18)

Yes the tubing is going off to the left along the intercooler where it then goes (into the DEFI unit and then goes) back thru into the car and connects upto the gauge.

The T piece fits inbetween the the pipe off the dump valve.

pauld37

Thanks Alex. Did you take power through the fuse box?

richiewong

T here
,

Mines powered from the stereo when I replaced that.

pauld37

Cheers Richie, powering it from the radio will be easier for me to do I think

richiewong

And here's the full effect:


(Sneaky post from work whilst its still quiet)

pauld37

Nice. Now get back to work

moneys

iTrader: (5)

When you do this off the dump valve what size T piece did you use? i:e what size pipe is it that comes off the dump valve? i need to re-fit my boost gauge to here as i was told it is more accurate but my pipe that goes to the boost gauge is only 3mm so i,m imagining that i need a different size for the other piping

pauld37

4mm o/d, 2.5mm i/d

milf hunter

thats what you want

moneys

iTrader: (5)

Where do i get one though?

alcazar

iTrader: (2)

You might get one at B&Q, Homebase, or a garden centre etc.

You could also try decent carshops, and Halfrauds.

Alcazar

colinversion8

hi guys im just gonna jump on and ask a quick question if thats ok,im fitting a greddy profec b spec 2 tommorrow,as long as it arrives,and i was wondering if someone could put a cirle on the engine above where i should T into the vacum line on the fuel reg? cheers for the help,i have searched to find info on this but couldn't find any pics,thanks for the help fella's

pauld37

moneys

iTrader: (5)

tried them all with no luck. bought a 2.7 i/d off e.bay so i,m going to see what its like, maybe put little clips on it if its to big. do you think it will effect the performance of the dump valve if its to small though?