DeltaDash readings
09 September 2002, 01:27 PM
#1
Scooby Regular
Thread Starter
Join Date: Feb 2002
Posts: 1,343
Likes: 0
Received 0 Likes
on
0 Posts
Hi guys,
I got the following readings from my DD. Remember I am only getting roughly .65 bar / 9-10psi of boost as my restricor is too big at the momment. Please advise:
rear 02 sensor volts:
When under full accerlation from 0 - 75 mph it was reading from .925 - 1.015; however, most readings were above 1.00, I take it this is far too rich ?
My waste gate duty percentage was usually between 45 and 55%, is this normal (again this was on a 0 - 75 mph blast) ?
Please advise
Cheers,
Ray
I got the following readings from my DD. Remember I am only getting roughly .65 bar / 9-10psi of boost as my restricor is too big at the momment. Please advise:
rear 02 sensor volts:
When under full accerlation from 0 - 75 mph it was reading from .925 - 1.015; however, most readings were above 1.00, I take it this is far too rich ?
My waste gate duty percentage was usually between 45 and 55%, is this normal (again this was on a 0 - 75 mph blast) ?
Please advise
Cheers,
Ray
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM