When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
59 plate
honestly look anywhere for Jdm 2.0 hatch downpipe, no one sells them and H&S say yeah we do but omg their jig is at least 2 inches out and pissed, because my rear box was so lobsided I had to have new tailpipes made as left pair where probably 2 inch further back than right pair
Milltek confirm they are discontinued. I had heard this 3 years ago, but as they were widely advertised I had assumed they were still available. I remember Lichfield selling his stock on ebay.
RCM Twinscroll downpipes fit the hatches. Including the spec c and R205. The only negative being they are a bit longer than the stocker, so you lose the little midpipe section and need to have it made up. Mine nearly doubled in volume with it fitted though. 3" decat.
if you're going to the hassle of doing the DP, do 3 port solenoid, actuator, fuel pump etc as well. You may make 310 or so at the wheels on a spec c turbo.
12 November 2020, 09:11 PM
