5x100 to 114.3 conversion
#1
Scooby Regular
Thread Starter
Join Date: Jan 2010
Location: the netherlands
Posts: 214
Likes: 0
Received 0 Likes
on
0 Posts
5x100 to 114.3 conversion
Can any one tell me how much I have to change to mount 114.3 hubs for the bigger bearings to my sti type-r 1999.
And is it possible to juse my 5x100 wheels to these hubs.
And is it possible to juse my 5x100 wheels to these hubs.
#2
New hubs and front shafts, fronts need to be machined to suit your gc suspension.
New brake discs and brackets or new calipers etc.
Its a very difficult modification hence very few people doing it
#3
Scooby Regular
Thread Starter
Join Date: Jan 2010
Location: the netherlands
Posts: 214
Likes: 0
Received 0 Likes
on
0 Posts
I thought the shafts and calipers would fit and yes the Hu b would get machined to fit the coilovers and I can get my ap racing bell machined to fit the hubs.
What would you think about fitting some adapter plates to fit my 5x100 wheels and disk's.
What would you think about fitting some adapter plates to fit my 5x100 wheels and disk's.
#6
Scooby Regular
Thread Starter
Join Date: Jan 2010
Location: the netherlands
Posts: 214
Likes: 0
Received 0 Likes
on
0 Posts
I like to now for shere.
And I have ap racing calipers will these fit and the rear calipers 2pot will these also fit.
And do I have to change somting for the rear fitment.
And I have ap racing calipers will these fit and the rear calipers 2pot will these also fit.
And do I have to change somting for the rear fitment.
Trending Topics
#8
Scooby Regular
Thread Starter
Join Date: Jan 2010
Location: the netherlands
Posts: 214
Likes: 0
Received 0 Likes
on
0 Posts
Can any one tell me the torque strength to fasten the bearings of a 114.3 hub.
And if i can refit old bearings to the adjusted hub.
And if i can refit old bearings to the adjusted hub.
Last edited by makkink; 26 October 2016 at 06:59 AM.
#9
Scooby Regular
iTrader: (2)
Join Date: Mar 2012
Location: somerset
Posts: 598
Likes: 0
Received 0 Likes
on
0 Posts
There's a good thread about this on 22b forum
A guy checked the bearing dimensions and although bigger diameter turns out the ***** are the same size...
Andy Forest machined his hubs to allow for double bearings, if you did this you could retain all your old bits like bells and wheels
Thread
Thread Starter
Forum
Replies
Last Post