v6wrx

iTrader: (2)

Finally had my flocked dashboard fitted great thanks to Ian! The only problem I have is the gauges are playing up when about to start the car they all flash and beep like they should but once the car is started they go off? Do they need to be setup again? Callum

The Pink Ninja

iTrader: (23)

Change where the lead is going to the meter input, you have 2 on the controller, you need to plug it into the black input 2, not the white input 1

v6wrx

iTrader: (2)

Cheers gaz top man!

The Trooper 1815

iTrader: (31)

Bugger, new it would be simple. Good day yesterday mate, glad your happy and we saved you a few bob .

The Pink Ninja

iTrader: (23)

I only know because ive been there myself

v6wrx

iTrader: (2)

Yeah simple fix. Just going to get the gauge pod fixed in today had some double tape. Thanks again for fitting it buddy. The polished intake to fit now may get stuck in to that today.

v6wrx

iTrader: (2)

So I pulled out from meter output one but it won't go in number 2 different size.

The Pink Ninja

iTrader: (23)

You sure? The last 2 ports on the right hand side of the controller, They both have the same amount of pins, Is it a Link controller 1 or 2(I have the 2) The DC Scource wont fit anywhere else and that is where the power comes from, Ive just copied this from another site where i got the info for mine from,

Constant 12V+ (Defi red wire) should go to the blue w/ red stripe wire on the radio harness.

Ignition 12V+ (Defi orange wire) should go to the green w/orange stripe on the A/C harness.

Illumination 12V+ (Defi white wire) should go to the violet wire on the radio harness.

Black Ground (Defi black wire) should go to the black wire on the radio harness.

Just check the wires but i`m sure its just a matter of changing from the white input 1 to the black input 2 and it should be right.

v6wrx

iTrader: (2)

Yeah Gaz you were right all sorted now cheers

v6wrx

iTrader: (2)