Right guys,ive had a bit of a bargain and picked up an EJ20 engine for next to nothing complete with crank,2 sets of rods,heads ect. The only problem is that one of the pistons melted and has scored the cylinder liner so would need a re-bore (i think) Im only looking to get that done so i can sell the bottom end off because i only really want the heads off it.
So does anyone know the rough cost of a re-bore?

 

ask dave co he had mine done but can't remember how much now it was around 150 i think

 

Try Huxtables or Swansea Autos both very good and pretty sure it'll be cheaper than £150

 

I second the above. Huxtables is the best, Swansea are very good and quick but I been told that they're a little messy. In other words you'd need to get the block cleaned before the rebuild

 

Where abouts are Huxtables guys? Never heard of them before

 

dave coe takes his to swansea autos anyway......

go and see brandon at swansea auto's 01792 771697

also how much you want for the block as i need one cause my block is knackered and so is the crank

 

I will see what condition its in when i pick it up either monday or tuesday next week and let you know

 

swansea auto is a good place to get it done used them in the past and spoke to them today and they were 170 pounds cheaper than where i had my rods put in.

 

He's is Birchgrove. It looks like an old farm, but he's **** hot. He's done a lot of machine work for the scooby rally boys

 

pick me up and ill take you up there
there on birchgrove road as you come out of heol las,little lane opposite