prodrive spring question please comment.
Is the prodrive spring kit for the STI 8 actualy meant to lower the car???
Since having them fitted to my STI it now sits 20 mil lower at the front and 10 mil higher at the back???????????????
Is this the way prodrive intended, or could the dealer have not fitted them properly?????????????????????
Your comments most welcome....
Since having them fitted to my STI it now sits 20 mil lower at the front and 10 mil higher at the back???????????????
Is this the way prodrive intended, or could the dealer have not fitted them properly?????????????????????
Your comments most welcome....
Scooby Regular
Joined: Jun 2004
Posts: 457
Likes: 0
From: www.cumbrianscoobs.co.uk It's Grim Up North
Recently had the Prodrive springs fitted to mine, still looks too high.
It is slightly lower at the front because the mudflaps were rubbing more, not sure about the rear!
It is slightly lower at the front because the mudflaps were rubbing more, not sure about the rear!
Both ends are lower but the front goes down a bit more than the back (car should have a slight nose down attitude for stability) Fitted mine myself so it's difficult to see how a dealer would fit them incorrectly (Mmmm - we're talking dealers here aren't we!) The front top spring cup can be misaligned but not the back. The springs will settle slightly with use although it actually shouldn't be higher to start with - that's for sure.
JohnD
JohnD
Thanks for the comments so far.
I have had these springs on four months now , and always thought they looked to high at back.
Yesterday i measured a std stis clearence from the tyre to the wheel arch and the prodrive springs on my car measured 10 mil higher than std??????????? from wheel to wheel arch mine measure 4.5 cm on the rear ??????????????????
I have had these springs on four months now , and always thought they looked to high at back.
Yesterday i measured a std stis clearence from the tyre to the wheel arch and the prodrive springs on my car measured 10 mil higher than std??????????? from wheel to wheel arch mine measure 4.5 cm on the rear ??????????????????
Originally Posted by s16cut
from wheel to wheel arch mine measure 4.5 cm on the rear ??????????????????
JohnD
Trending Topics
Originally Posted by mmmiddy
Is it possible that you've ordered or they've fitted WRX springs by mistake?
Just a thought, worth checking the part numbers.
Just a thought, worth checking the part numbers.
Measured them as JohnD recommended and they are the same as his so this must be how they are,the car looks to high so i think im disapointed .The eiback ride hight looks perfect ,better ride quality though ,some consulation but might swop them for the eibacks...
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
20
Oct 22, 2015 06:12 AM



