Recently purchased an import WRX bugeye and found the front springs are coil bound so I'm looking for replacement springs with standard shockers was looking for prodrive springs but no luck so what fits and is as good H&R, tein, eibach looking for more performance than stance thanks.

 

You can get prodive springs from http://www.pcadynamics.com

 

thanks brilliant

 

If you use the PCA dynamics blob/hawk wrx springs, with your bug dampers, you're going to need rear blob/hawk top mounts and rear washers/ spacers.
Those springs, on a bug, will not be quite as lowered as a blob/hawk wrx would be, as the bug is lighter.

Change the bump stops at the same time - as the pca springs come with internal bump stops, for inverted dampers.

Front stops - Febi 27848 - use dome side up.
http://www.ebay.co.uk/itm/FEBI-27848...EAAOSwcu5UNJff

Rear stops/dust boots (if using the later blob/hawk rear top mounts) - KYB 910046
http://www.ebay.co.uk/itm/Rear-Prote...QAAOSw37tWBfNc

Spacers required (if using bug rear struts, with blob/hawk rear top mounts) - http://www.fastwrx.com/products/tic-...-strut-spacers

Spacers - Pedders version - don't know what material they're made of? - Fitting Instructions PEDDERS 5052 - Pedders Suspension UK

http://www.pedders.co.uk/strut-fitti...t_p4512840.htm

Or

http://www.rhdjapan.com/rs-r-suspens...a-gda-gdb.html

 

2pot knows his stuff.

 

ok if I put H&R on for A bugeye are they a direct swap. will be having some bilstein b16 by the end of the year. but with the fronts being coil bound sport springs will do for the time being.

 

Took the apex off and put H&R sports springs on the only problem I have is which way to the spring top hats fit I don't seem to fine aliment marks????