DD24

iTrader: (1)

Recently purchased an import WRX bugeye and found the front springs are coil bound so I'm looking for replacement springs with standard shockers was looking for prodrive springs but no luck so what fits and is as good H&R, tein, eibach looking for more performance than stance thanks.

InTurbo

iTrader: (3)

You can get prodive springs from http://www.pcadynamics.com

DD24

iTrader: (1)

thanks brilliant

2pot

iTrader: (3)

If you use the PCA dynamics blob/hawk wrx springs, with your bug dampers, you're going to need rear blob/hawk top mounts and rear washers/ spacers.
Those springs, on a bug, will not be quite as lowered as a blob/hawk wrx would be, as the bug is lighter.

Change the bump stops at the same time - as the pca springs come with internal bump stops, for inverted dampers.

Front stops - Febi 27848 - use dome side up.
http://www.ebay.co.uk/itm/FEBI-27848...EAAOSwcu5UNJff

Rear stops/dust boots (if using the later blob/hawk rear top mounts) - KYB 910046
http://www.ebay.co.uk/itm/Rear-Prote...QAAOSw37tWBfNc

Spacers required (if using bug rear struts, with blob/hawk rear top mounts) - http://www.fastwrx.com/products/tic-...-strut-spacers

Spacers - Pedders version - don't know what material they're made of? - Fitting Instructions PEDDERS 5052 - Pedders Suspension UK

http://www.pedders.co.uk/strut-fitti...t_p4512840.htm

Or

http://www.rhdjapan.com/rs-r-suspens...a-gda-gdb.html

InTurbo

iTrader: (3)

2pot knows his stuff.

DD24

iTrader: (1)

ok if I put H&R on for A bugeye are they a direct swap. will be having some bilstein b16 by the end of the year. but with the fronts being coil bound sport springs will do for the time being.

DD24

iTrader: (1)

Took the apex off and put H&R sports springs on the only problem I have is which way to the spring top hats fit I don't seem to fine aliment marks????