3" Backbox
#4
The three hangers on this is almost spot on for my car, in fact I have fitted it and its spot on in situ, but the angle of the piping is ever so slightly out, and as such I would need to heat it up and bending into position, and also twist the flange of the connector 20 degrees to fit my Miltek set up, hence its not really worth it for me that much.
If unsold I will adapt it to fit, but I just cannot be bothered at the moment
Rob
#5
There is a little more to it for this against my set up, obvioulsy a lot of exhausts are bespoke fitments, so that you are forced to buy the 'counter part' sections for a perfect fit.
The three hangers on this is almost spot on for my car, in fact I have fitted it and its spot on in situ, but the angle of the piping is ever so slightly out, and as such I would need to heat it up and bending into position, and also twist the flange of the connector 20 degrees to fit my Miltek set up, hence its not really worth it for me that much.
If unsold I will adapt it to fit, but I just cannot be bothered at the moment
Rob
The three hangers on this is almost spot on for my car, in fact I have fitted it and its spot on in situ, but the angle of the piping is ever so slightly out, and as such I would need to heat it up and bending into position, and also twist the flange of the connector 20 degrees to fit my Miltek set up, hence its not really worth it for me that much.
If unsold I will adapt it to fit, but I just cannot be bothered at the moment
Rob
Good luck with the sale bud..
#6
hi
this looks like a japspeed backbox, which the bolts holes are rotated as described but the backbox pipe(to the centre section) wasnt long enough to fit. as i had this problem when i wanted to change the back box.
steve
this looks like a japspeed backbox, which the bolts holes are rotated as described but the backbox pipe(to the centre section) wasnt long enough to fit. as i had this problem when i wanted to change the back box.
steve
#7
Bump anyone... I'll give it until this weekend, then Im going to get my welding mask on
Rob
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post