Scoop after FMIC fitting
#1
Scoop after FMIC fitting
After fitting the FMIC and removing the splitter/rubber skirt from under the scoop, I've put a section of mesh over the hole. I'm a bit concerned about the rain and crap that could find it's way into the engine bay. What have people put under the scoop? (Considered a cold air feed to the filter but not sure ducting would clear?)
JohnD
JohnD
Trending Topics
#8
Former Sponsor
iTrader: (48)
Exactly as above. I removed the scoop when I went FMIC on a particular car as I wanted to go for the "Sport" look. A real sleeper. I soon decided, after using max min thermometer, infra red thermometer and observing ACTs that this was not a good idea.
I would leave the scoop in position. Remove the under tray if you wish. No mesh or anything else required.
I would leave the scoop in position. Remove the under tray if you wish. No mesh or anything else required.
#9
BANNED
iTrader: (20)
Exactly as above. I removed the scoop when I went FMIC on a particular car as I wanted to go for the "Sport" look. A real sleeper. I soon decided, after using max min thermometer, infra red thermometer and observing ACTs that this was not a good idea.
I would leave the scoop in position. Remove the under tray if you wish. No mesh or anything else required.
I would leave the scoop in position. Remove the under tray if you wish. No mesh or anything else required.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM