Any tips please chaps.
#1
Any tips please chaps.
Got a few hours spare today so fancy tackling a job I've been putting off.
Currently got crystal clear headlights and black crystal side lights. Was searching for some black headlights to match the sides when somebody mentioned that it's possible to spray my current lights.
Was given some simple advice which involved an oven, masking tape, black paint and some silicone sealer.
Anybody got and tips and/or advice that will help me today, or even a step through guide from someone who has done it.
Thanks as always chaps,
Matt.
Currently got crystal clear headlights and black crystal side lights. Was searching for some black headlights to match the sides when somebody mentioned that it's possible to spray my current lights.
Was given some simple advice which involved an oven, masking tape, black paint and some silicone sealer.
Anybody got and tips and/or advice that will help me today, or even a step through guide from someone who has done it.
Thanks as always chaps,
Matt.
#2
Scooby Regular
Not quite what your doing but should be almost the same in temrs of how to open the lights up etc.
http://forums.nasioc.com/forums/show...hreadid=384488
http://forums.nasioc.com/forums/show...hreadid=384488
Last edited by NOSSY_89; 19 November 2011 at 01:03 PM.
#3
Thanks Nossy.
Got them done today...
Heated both lights up in the oven for 10mins.
Removed clips and separated the glass from the unit.
Removed small screw that holds inner plastics, removed said plastics.
Flatted off, primed, 4 coats of matt black.
Fitted plastics back into unit.
Placed glass back onto main body.
Reheated for 10 mins.
Pushed glass tight against unit and refitted metal clips.
Job done.
From this -
To this -
Very happy, looks much better.
Pictures don't do the change justice but looks much better in the flesh (or metal)
Got them done today...
Heated both lights up in the oven for 10mins.
Removed clips and separated the glass from the unit.
Removed small screw that holds inner plastics, removed said plastics.
Flatted off, primed, 4 coats of matt black.
Fitted plastics back into unit.
Placed glass back onto main body.
Reheated for 10 mins.
Pushed glass tight against unit and refitted metal clips.
Job done.
From this -
To this -
Very happy, looks much better.
Pictures don't do the change justice but looks much better in the flesh (or metal)
Trending Topics
#9
Scooby Regular
iTrader: (52)
The seats are factory to my Prodrive edition but are also in the CM edition model yes.
Cheers mate the bonnet cost a few pennies though lol but does look sweet!
Thread
Thread Starter
Forum
Replies
Last Post
Uncle Creepy
Other Marques
43
27 December 2015 04:02 PM
trapper2013
ScoobyNet General
6
30 October 2015 03:10 PM