Limiter Cutting in too soon
I 've got a Garret 28 Series Blower which kicks in at around 3,500 and pulls all the way to 6,000.
Twice today when I was overtaking, the limiter and cut out the engine at 4,000 revs!
Bit scary really, then the orange warning light came on. On both occasions after I'd stopped and locked the Scoob up and went out and about, when I returned it had gone out.
Had a remap 3-4 months ago and very happy with it.
Any ideas? I
'm thinking of doing a bit more work on the scoob down pipes and things and, was going to get it remapped again afterwards. Any advice greatfully accepted.
Kind regards
Alan MaC
Twice today when I was overtaking, the limiter and cut out the engine at 4,000 revs!
Bit scary really, then the orange warning light came on. On both occasions after I'd stopped and locked the Scoob up and went out and about, when I returned it had gone out.
Had a remap 3-4 months ago and very happy with it.
Any ideas? I
'm thinking of doing a bit more work on the scoob down pipes and things and, was going to get it remapped again afterwards. Any advice greatfully accepted.
Kind regards
Alan MaC
sounds like the car is going into 'safe mode'. It automatically limits the revs so as not to cause more damage - borrow a s.e.c.s unit and read the fault codes or get it on a diagnostic machine sooner rather than later
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM
supshon
General Technical
2
Oct 3, 2015 08:06 PM



