How do you fit a SX fuel pressure reg on a classic??
#1
Scooby Regular
Thread Starter
Join Date: Aug 2003
Location: Teesside
Posts: 1,247
Likes: 0
Received 0 Likes
on
0 Posts
How do you fit a SX fuel pressure reg on a classic??
As above does anyone have any instructions/pics please??? to Fit to a MY99 STI.
Thanks
Chris
Thanks
Chris
#7
Former Sponsor
iTrader: (48)
You need an adaptor for the fuel rail, available from AS Performance and others.
This is located above #3 cylinder, just in front of driver.
You need 1-2 meters of FUEL HOSE, black rubber, not any other hose like HP AIR. some jubilee clips or similar.
Decide where you are locating the SX. Bulkhead or on the engine above #4 cylinder is handy and keeps pipe run to a minimum.
Feed from the adaptor on the fuel rail to the SX inlet which is one of the two top side ports. The other port, for your application, is either for a guage or sender.
The return is from the bottom of the SX and that feeds to the vehicle return which from memory is the top pipe on the passenger side bulkhead and coloured grey.
This is located above #3 cylinder, just in front of driver.
You need 1-2 meters of FUEL HOSE, black rubber, not any other hose like HP AIR. some jubilee clips or similar.
Decide where you are locating the SX. Bulkhead or on the engine above #4 cylinder is handy and keeps pipe run to a minimum.
Feed from the adaptor on the fuel rail to the SX inlet which is one of the two top side ports. The other port, for your application, is either for a guage or sender.
The return is from the bottom of the SX and that feeds to the vehicle return which from memory is the top pipe on the passenger side bulkhead and coloured grey.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM