power graph for 94 wagon
#1
power graph for 94 wagon
hi could anyone have a look at this power graph of my 94 wrx wagon and tell me if it looks ok i know it is down on power but its only running 0.75bar of boost at the minute dawes to be fitted , just wondered if torque curve, rate power dropped of , etc looked ok cheers
http://img57.photobucket.com/albums/...ower_graph.jpg
stu
http://img57.photobucket.com/albums/...ower_graph.jpg
stu
#3
hiya
try an ecu reset to clear all the fault codes and advance the timing. I did this and it drove a lot better.
Also use opitmax and clean out the boost solenoid pipes with wd40
make sure you rset the ecu last. I.e black and green connectors
other than that try plugs/service
good luck
andy
try an ecu reset to clear all the fault codes and advance the timing. I did this and it drove a lot better.
Also use opitmax and clean out the boost solenoid pipes with wd40
make sure you rset the ecu last. I.e black and green connectors
other than that try plugs/service
good luck
andy
#5
Scooby Regular
iTrader: (2)
Join Date: May 2000
Location: Class record holder at Pembrey Llandow Goodwood MIRA Hethel Blyton Curborough Lydden and Snetterton
Posts: 8,626
Likes: 0
Received 0 Likes
on
0 Posts
TBH its about right.
Its a 94WRX wagon so its 220PS on 100RON fuel, which equates to about 210BHP on UK fuel at a guess.
Powerstations rollers are the most conservative there are - you'd have got 220 at PE's rollers at a guess.
0.75 bar may well be right for a car on the rollers - it may make 0.8 - 0.9 on the road, but on the rollers heat soak on your piddly slanty IC will take effect and drop boost.
The torque curve is good - nice tabletop, if I were being picky I'd have thought the TD04 would have come in 250rpm quicker, but then again it may well do on the road.
Have a look for the Wagon ScoobyECU in the group buy forum, if you want more power, it can be used in conjunction with a Dawes.
Its a 94WRX wagon so its 220PS on 100RON fuel, which equates to about 210BHP on UK fuel at a guess.
Powerstations rollers are the most conservative there are - you'd have got 220 at PE's rollers at a guess.
0.75 bar may well be right for a car on the rollers - it may make 0.8 - 0.9 on the road, but on the rollers heat soak on your piddly slanty IC will take effect and drop boost.
The torque curve is good - nice tabletop, if I were being picky I'd have thought the TD04 would have come in 250rpm quicker, but then again it may well do on the road.
Have a look for the Wagon ScoobyECU in the group buy forum, if you want more power, it can be used in conjunction with a Dawes.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jonny mac
ScoobyNet General
10
09 October 2015 12:25 PM