When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Can anyone give me the wiring diagram for hawkeye and blob headlights?
Need to wire the hawkeye headlights into the Blob loom. These looks to he HIDs as there are what appears to be ballasts on the bottom of both units.
Had a search and a look online, one of the connectors I have has a yellow wire with a black stripe and I haven't been able to find anything that mentions this colour... Hence I'm asking for help.
OK I'm struggling to decipher these. My car is a 53 plate so guessing wiring colours may be different? Even so, something I'm struggling with a bit is the Blob uses a main 6 pin connector doesn't it? (I got the car without headlights so can't look at the Blob ones for reference)
So on the diagram that suggests only 4 wires are for the high and low beams. Does that mean the other two are for sidelights? And indicators are a separate plug? Or vice versa?
I also don't see a 6 pin plug listed on that blob diagram and I'm struggling to figure out where the wires meet the 8 pin plug on the hawkeye diagram...
Rear view of a Blobeye Headlight (ignore the red lines as it comes from another Snet thread)
As it's a 53 plate it is more likely a MY04 but looking at the various wiring diagrams the wiring and colour coding seem much the same through the MY03-05 years (unless it's JDM)
Headlights Low and High beam use the grey and black 2 pin connectors.
The black(with some brown rust?) 3 pin connector (bottom left, being for clearance light and turn signals.
Have attached additional Blobeye wiring diagram pages as a pdf
Additional Hawk pages here
Last edited by Don Clark; 07 July 2023 at 05:46 AM.
OK, it would appear that the plugs on my car match up to these headlights:
Which appear to be JDM Xenons. Not what I was expecting. I got it with the Hawk front wings and front panel already on. Thought it was a non Xenon UK car. Not fully sure how to rewire yet but I think I'm starting to get a handle on it. Just not sure how to get the levelling motors connected yet but I'll get there. Hopefully.
One I figure out which wire does what in the Hawk plug, I should be able to make some progress.