Do we have any machinists on?
#1
Scooby Regular
Thread Starter
Join Date: Feb 2004
Location: High Wycombe
Posts: 3,763
Likes: 0
Received 0 Likes
on
0 Posts
Do we have any machinists on?
I'm really struggling to find a part on-line or anywhere in fact.
What I'm looking for is similar to this:
But with the thread 7/16 x 28 unef.
I should be able to source a die which will make life easier.
Does someone fancy earning some beer tokens?
How would I go about getting 50 of these if the trial works?
J
What I'm looking for is similar to this:
But with the thread 7/16 x 28 unef.
I should be able to source a die which will make life easier.
Does someone fancy earning some beer tokens?
How would I go about getting 50 of these if the trial works?
J
#2
Scooby Regular
iTrader: (2)
Turned in what material? And do they need to be anodised?
And is that 7/16 x 28 unf?
What are the other dimensions, and I assume it's drilled, I'll need the diameter of that too.
A local lad used to work for a machinist, they might be interested.
And is that 7/16 x 28 unf?
What are the other dimensions, and I assume it's drilled, I'll need the diameter of that too.
A local lad used to work for a machinist, they might be interested.
Last edited by alcazar; 13 May 2015 at 04:52 PM.
#3
Scooby Regular
Thread Starter
Join Date: Feb 2004
Location: High Wycombe
Posts: 3,763
Likes: 0
Received 0 Likes
on
0 Posts
Pretty sure it's UNEF for extra fine.
It's a special thread used in EN 417 applications (disposable gas cylinders).
Yes it's drilled.
Doesn't need to be anodised. Brass / Alu would probably work.
Internal dia, not sure - whatever he can get away with without losing strength.
The outlet would be an 8mm Nozzle
It's a special thread used in EN 417 applications (disposable gas cylinders).
Yes it's drilled.
Doesn't need to be anodised. Brass / Alu would probably work.
Internal dia, not sure - whatever he can get away with without losing strength.
The outlet would be an 8mm Nozzle
Last edited by BlkKnight; 13 May 2015 at 05:09 PM.
Thread
Thread Starter
Forum
Replies
Last Post
evolvedgsr
Suspension
0
13 September 2014 08:59 PM
radave
Subaru Parts
10
21 April 2014 08:12 AM