PSI3 ECU DATA MONITOR
#1
PSI3 ECU DATA MONITOR
I have a PSI3 ecu data monitor.
This morning i switched on my ignition and the screen came up with a load on numbers, letters etc. It never even came up with the welcome stuff which it does normaly.
I unpluged the unit and now it just has a blank yellow screen when it comes on.
Can you reset the unit?
cheers Andy
This morning i switched on my ignition and the screen came up with a load on numbers, letters etc. It never even came up with the welcome stuff which it does normaly.
I unpluged the unit and now it just has a blank yellow screen when it comes on.
Can you reset the unit?
cheers Andy
#2
Scooby Regular
iTrader: (1)
nope.. either the screen has gone or the rom chip has come loose (has done in mine before).. you'll need to take it apart though and make sure the chip is pushed home firmly in the board (its about 2cm square) if that doesn't work then try pm'ing spi3.. good luck on that..
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM