Omex shiftlight
05 May 2006, 10:14 AM
#1
Scooby Regular
Thread Starter
Join Date: Nov 2002
Location: Denmark
Posts: 292
Likes: 0
Received 0 Likes
on
0 Posts
Omex shiftlight
I´m trying to connect a Omex Shiftlight Pro to my ´02 WRX but I just can´t get the thing to light up.
It has 3 wires. Blue, red and black. The blue one I´ve connected to the green from the tacho. The red one to positive from ignition and the black one to ground. I´m sure it´s powered because the small LED´s are lighting up when I´m adjusting rpm and cylinder settings (OMEX doesen´t use pills).
One problem is which green wire from the tacho to use.There are two. One is green/yellow and one is green/black. Which one to use? I tried them both.
I called Omex, and they suggested to use a resistor between the blue and the red wire.
It has 3 wires. Blue, red and black. The blue one I´ve connected to the green from the tacho. The red one to positive from ignition and the black one to ground. I´m sure it´s powered because the small LED´s are lighting up when I´m adjusting rpm and cylinder settings (OMEX doesen´t use pills).
One problem is which green wire from the tacho to use.There are two. One is green/yellow and one is green/black. Which one to use? I tried them both.
I called Omex, and they suggested to use a resistor between the blue and the red wire.
Thread
Thread Starter
Forum
Replies
Last Post