Will I be able to fit...
#1
Scooby Regular
Thread Starter
Join Date: Apr 2010
Location: ednburgh
Posts: 441
Likes: 0
Received 0 Likes
on
0 Posts
Will I be able to fit...
The centre pipe on my newage wrx without a remap. Iv spent a while reading threads about fitting systems some say they're ok to run others say they need mapped ASAP. I know to gain the full benefit it's best to remap which I will be doing at a later date. I'm going to be changing the parts myself in my garage and was planning to do it over a short period. I was going to start by removing centre pipe then uppipe and so on. My final spec before mapping will be td05 18g full system inc up pipe, injectors , fuel pump, y pipe(fitted) and panel filter.
#4
Scooby Regular
Thread Starter
Join Date: Apr 2010
Location: ednburgh
Posts: 441
Likes: 0
Received 0 Likes
on
0 Posts
Iv changed the resonator section to a straight through but I'm not needing to take the cats out to fit the system. I won't be fitting turbo and injectors until I'm close to mapping date. Just wondered if taking the cars out will harm the car driving off boost? Could be for a couple months tho.
#7
Scooby Regular
iTrader: (1)
Join Date: Sep 2013
Location: newquay
Posts: 194
Likes: 0
Received 0 Likes
on
0 Posts
ive got a decat, cone filter and upgraded y pipe on my turbo 2000 without a remap but it doesnt boost over 13psi. will this be causing damage? when i got it, it was running off the actuator (7psi) so i took it to the engine tuner in plymouth and he reconnected it back up right, he didnt say it would do any damage
Thread
Thread Starter
Forum
Replies
Last Post
WhiteWagonMan
Subaru Parts
26
06 March 2015 02:07 PM