Idle Low on Ecutek Remap
#4
Scooby Regular
Join Date: Jul 2005
Location: www.bbscoobys.com
Posts: 716
Likes: 0
Received 0 Likes
on
0 Posts
sounds a touch too low, I wouldn't have thought the mapper would alter the idle.........
Sure its not just a dirty idle control valve? I suppose that would make the idle fluctuate rather than sit low?
Sure its not just a dirty idle control valve? I suppose that would make the idle fluctuate rather than sit low?
Last edited by Bristol98; 28 May 2012 at 11:53 AM.
#5
Scooby Regular
Join Date: Nov 2006
Location: Enginetuner.co.uk Plymouth Dyno Dynamics RR Engine machining and building EcuTek SimTek mapping
Posts: 3,662
Likes: 0
Received 0 Likes
on
0 Posts
When the ECU is re set the idle goes back to a base setting. It just needs a tweak which can be done by any mapper with Deltadash or any Subaru dealer.
A dirty idle valve more often than not results in a high idle speed.
A dirty idle valve more often than not results in a high idle speed.
#6
Scooby Regular
iTrader: (2)
Join Date: Jan 2004
Location: Hertfordshire
Posts: 4,312
Likes: 0
Received 0 Likes
on
0 Posts
How are you measuring the idle speed? The line just above the 500rpm on the stock rev counter is where it should sit. this appears to be around 650 but is infact higher than that if checked on a laptop. providing its a nice steady idle and it doesnt cut out then dont worry.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
supshon
General Technical
2
03 October 2015 08:06 PM