engine check light
07 September 2010, 02:52 PM
#1
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Jan 2010
Posts: 426
Likes: 0
Received 0 Likes
on
0 Posts
engine check light
hi guys was on my way home today and started to give car a bit of welly on duel carriage way and when i glanced down the engine check light was on , ok i thought was just because of going fast but has i got nearer home engine cut out had to bump start it at round about and car engine started to rattle and tick over pretty ruff had to do this a few more times before i got home , so put my code reader on and it came up with this fault code P0340 Camshaft Position Sensor Circuit Malfunction
car start up after a bit and at 2000 revs it is rattling like a good un any advice about this , has im starting to think engine is fu$ked many thanks inadvance
car start up after a bit and at 2000 revs it is rattling like a good un any advice about this , has im starting to think engine is fu$ked many thanks inadvance
07 September 2010, 02:58 PM
#2
Scooby Regular
iTrader: (6)
Join Date: Jan 2009
Location: on sunny ibiza ocean beach
Posts: 5,594
Likes: 0
Received 0 Likes
on
0 Posts
hi guys was on my way home today and started to give car a bit of welly on duel carriage way and when i glanced down the engine check light was on , ok i thought was just because of going fast but has i got nearer home engine cut out had to bump start it at round about and car engine started to rattle and tick over pretty ruff had to do this a few more times before i got home , so put my code reader on and it came up with this fault code P0340 Camshaft Position Sensor Circuit Malfunction
car start up after a bit and at 2000 revs it is rattling like a good un any advice about this , has im starting to think engine is fu$ked many thanks inadvance
car start up after a bit and at 2000 revs it is rattling like a good un any advice about this , has im starting to think engine is fu$ked many thanks inadvance
07 September 2010, 06:13 PM
#5
Scooby Regular
Thread Starter
iTrader: (4)
Join Date: Jan 2010
Posts: 426
Likes: 0
Received 0 Likes
on
0 Posts
(only problem hes in bradford and the only 1 i trust to do it )
Last edited by jaymaxy; 07 September 2010 at 06:14 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
TylerD529
Lighting and Other Electrical
5
20 September 2015 12:10 PM