Oil catch tank installation on V4 impreza?
#2
Scooby Regular
iTrader: (12)
Join Date: Mar 2009
Location: in a house
Posts: 2,078
Likes: 0
Received 0 Likes
on
0 Posts
is it not the same as v3?
on the rocker covers there is a pip coming off the tops. this also joins to the bottom of the inlet at the back. well the block really. all i did was use a t piece to join the left and back and then to the catch tank and then from the right straight to the catch tank as well.
mounting is where you can place it
hope that helps a little
on the rocker covers there is a pip coming off the tops. this also joins to the bottom of the inlet at the back. well the block really. all i did was use a t piece to join the left and back and then to the catch tank and then from the right straight to the catch tank as well.
mounting is where you can place it
hope that helps a little
#3
Cheers. Yes it is the same as the V3. I looked at the guide in the technical archice section but that guide is for the V1/2 which has a different inlet compared to the V3/4. I know its not difficult just need to know where the pipes plumb into. Do you have a overflow pipe going from the tank to the chasis?
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
38
17 July 2016 10:43 PM
JonMc
Subaru Parts
22
06 February 2016 09:50 PM
ATWRX
Full Cars Breaking For Spares
88
01 February 2016 07:28 PM
af, catch, cvatch, fit, impreza, instal, install, installation, installing, isntalation, montering, mounting, oil, subaru, tank