Boost guage install
#1
I have just received my Blitz boost gauge, I am fitting it to my UK STI. Can anyone tell me where the best place to take a feed for from is. I cannot see anything like there was on my old my00 manifold.
THANKS
Rich
[Edited by rs - 3/19/2002 7:00:02 PM]
THANKS
Rich
[Edited by rs - 3/19/2002 7:00:02 PM]
#2
From what i gathered from a friend of mine is you can connect them to one of two lugs on the top of the engine towards the front. The ones over here are covered over by a thin rubber cap which you can just pull off. Does this sound right to anyone else?
#6
Cut the pipe shown on the illustration. Insert a T - Piece in it's place. Feed your gauge from this.
That's what I did, and it works a treat.
Jon
Click here for picture (120 Kb): http://draft.monster.co.uk/jon/boost.jpg
That's what I did, and it works a treat.
Jon
Click here for picture (120 Kb): http://draft.monster.co.uk/jon/boost.jpg
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post