Car struggles to hit 4k revs
#1
Car struggles to hit 4k revs
Hi all. I just been out in car and it is struggling to reach 3.5k-4k revs. Boost guage goes to 0 and stays there. Car does not have engine light showing and also car has no noises/rattles. The only thing i have done recently to car was add the bung for exhaust.
I will check engine codes in morning as it is dark now. Only things i can think that caused the problem are:
Thanks.
Paul
I will check engine codes in morning as it is dark now. Only things i can think that caused the problem are:
- Loose hose/pipe (had a quick look and can't see any loose)
- MAF or C02 (would they not put engine light on?)
- Turbo dead (Although when i revved hard bov tries to kick in)
- Bung in exhaust (can not see that stopping revs)
Thanks.
Paul
#4
Right i think it is sorted now. Went out earlier to check if any error codes and it came back with nothing. So lifted bonnet to see if anything is out of place. I found a piece had come off on the turbo. The metal rod on the actuator had come off the it's pin. Put it back on and started car and did a quick hard rev and bov kicked in so looks like it is sorted. Will know later when i go and book service.
Paul
Paul
#6
Scooby Regular
iTrader: (2)
There should be a circlip to hold the rod on the pin - if missing then put another on.
Needing to adjust the rod length depends on how tight the locking nut is (if fitted). With the rod loose and flapping around there is a chance for the rod to wind out longer by itself.
Nick
Needing to adjust the rod length depends on how tight the locking nut is (if fitted). With the rod loose and flapping around there is a chance for the rod to wind out longer by itself.
Nick
#7
I am guessing the circlip as gone as i never seen it when i put rod back on. Will any circlip do or does it need to be a certain type? Halfrauds do a bag of mixed sizes for £7. Thanks
Paul
Paul
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM