Only making half the boost - any ideas???
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Aug 2006
Location: West Sussex
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
Only making half the boost - any ideas???
Hi guys
just bought my WRX and it has an ecutek ecu and a PSi3 digital display in the dash.
It was meant to be running 1.39 bar and approx 340bhp...however when i looked at the display last night for the first time when booting it i noticed its only making 0.65 bar....
there also doesnt seem to be any boost control devices in the engine...?
would the ecutek be set up to 1.39bar in that case? therefore theres a blockage maybe? HELP??!!!
any ideas?
just bought my WRX and it has an ecutek ecu and a PSi3 digital display in the dash.
It was meant to be running 1.39 bar and approx 340bhp...however when i looked at the display last night for the first time when booting it i noticed its only making 0.65 bar....
there also doesnt seem to be any boost control devices in the engine...?
would the ecutek be set up to 1.39bar in that case? therefore theres a blockage maybe? HELP??!!!
any ideas?
#3
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Aug 2006
Location: West Sussex
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
thanx Paul
I will check the T-piece thing and the resistor tonight hopefully - and re-set the ecu.
so is the map on the bar basically programmed through the restrictor under the compressor cover?
I will check the T-piece thing and the resistor tonight hopefully - and re-set the ecu.
so is the map on the bar basically programmed through the restrictor under the compressor cover?
Thread
Thread Starter
Forum
Replies
Last Post
hedgecutter
General Technical
3
25 September 2015 02:35 PM
aaron_ions
General Technical
14
25 September 2015 02:33 PM
Mister:E
Subaru Parts
2
24 September 2015 01:37 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM